[100% Pass Cisco Dumps] The Most Recommended Cisco 300-101 Dumps ROUTE v2 with Verified Exam Answers Download With High Quality (From Google Drive)

Where can I get study material for new Cisco 300-101 dumps? “Implementing Cisco IP Routing” is the name of Cisco 300-101 exam dumps which covers all the knowledge points of the real Cisco exam. The most recommended Cisco 300-101 dumps ROUTE v2 with verified exam answers download with high quality. Pass4itsure Cisco 300-101 dumps exam questions answers are updated (476 Q&As) are verified by experts.

The associated certifications of 300-101 dumps is CCDP. With 300-101 exam dumps from Pass4itsure, we provide guaranteed success rate for the Cisco https://www.pass4itsure.com/300-101.html dumps exam. We provide latest and updated question answers for Cisco Implementing Cisco IP Routing (ROUTE v2.0) exam for preparation.

Exam Code: 300-101
Exam Name: Implementing Cisco IP Routing
Updated: Sep 12, 2017
Q&As: 476

[100% Pass Cisco 300-101 Dumps From Google Drive]: https://drive.google.com/open?id=0BwxjZr-ZDwwWWDdYaFM0SVFwMTA

[100% Pass LX0-101 Dumps From Google Drive]: https://drive.google.com/open?id=0BwxjZr-ZDwwWV283ZkNtUVctRm8

300-101 dumps

QUESTION 5
Which method allows IPv4 and IPv6 to work together without requiring both to be used for a single connection during the migration process?
A. dual-stack method
B. 6to4 tunneling
C. GRE tunneling
D. NAT-PT
300-101 exam 
Correct Answer: A
Explanation
Explanation/Reference:
Explanation:
Dual stack means that devices are able to run IPv4 and IPv6 in parallel. It allows hosts to simultaneously reach IPv4 and IPv6 content, so it offers a very flexible
coexistence strategy. For sessions that support IPv6, IPv6 is used on a dual stack endpoint. If both endpoints support IPv4 only, then IPv4 is used.
Benefits:
Native dual stack does not require any tunneling mechanisms on internal networks
Both IPv4 and IPv6 run independent of each other
Dual stack supports gradual migration of endpoints, networks, and applications.
QUESTION 6
Which statement about the use of tunneling to migrate to IPv6 is true?
A. Tunneling is less secure than dual stack or translation.
B. Tunneling is more difficult to configure than dual stack or translation.
C. Tunneling does not enable users of the new protocol to communicate with users of the old protocol without dual-stack hosts.
D. Tunneling destinations are manually determined by the IPv4 address in the low-order 32 bits of IPv4-compatible IPv6 addresses.
Correct Answer: C
Explanation
Explanation/Reference:
Explanation:
Using the tunneling option, organizations build an overlay network that tunnels one protocol over the other by encapsulating IPv6 packets within IPv4 packets and IPv4 packets within IPv6 packets. The advantage of this 300-101 dumps approach is that the new protocol can work without disturbing the old protocol, thus providing connectivity between users of the new protocol. Tunneling has two disadvantages, as discussed in RFC 6144: Users of the new architecture cannot use the services of the underlying infrastructure. Tunneling does not enable users of the new protocol to communicate with users of the old protocol without dual-stack hosts, which negates interoperability.
QUESTION 7
A network administrator executes the command clear ip route. Which two tables does this command clear and rebuild? (Choose two.)
A. IP routing
B. FIB
C. ARP cache
D. MAC address table
E. Cisco Express Forwarding table
F. topology table

300-101 pdf Correct Answer: AB
Explanation
Explanation/Reference:
Explanation:
To clear one or more entries in the IP routing table, use the following commands in any mode:
Command Purpose
clear ip route {* |
Clears one or more routes from both the
{route |
unicast RIB and all the module FIBs. The
prefix/length}[next-hop route options are as follows:
interface]}
· *–All routes.
[vrf vrf-name]
Example:
· route–An individual IP route.
switch(config)# clear ip
· prefix/length–Any IP prefix.
route
10.2.2.2
· next-hop–The next-hop address
· interface–The interface to reach the
next-hop address.
The vrf-name can be any case-sensitive, al
phanumeric string up to 32 characters.
QUESTION 8
Which switching method is used when entries are present in the output of the command show ip cache?
A. fast switching
B. process switching
C. Cisco Express Forwarding switching
D. cut-through packet switching
300-101 vce 
Correct Answer: A
Explanation
Explanation/Reference:
Explanation:
Fast switching allows higher throughput by switching a packet using a cache created by the initial packet sent to a particular destination. Destination addresses are stored in the high-speed cache to expedite forwarding. Routers offer better packet-transfer performance when fast switching is enabled. Fast switching is enabled by default on all interfaces that support fast switching. To display the routing table cache used to fast switch IP traffic, use the “show ip cache” EXEC command.
Reference:
QUESTION 9
Which two actions must you perform to enable and use window scaling on a router? (Choose two.)
A. Execute the command ip tcp window-size 65536.
B. Set window scaling to be used on the remote host.
C. Execute the command ip tcp queuemax.
D. Set TCP options to “enabled” on the remote host.
E. Execute the command ip tcp adjust-mss.
300-101 exam 
Correct Answer: AB
Explanation
Explanation/Reference:
Explanation:
The TCP Window Scaling feature adds support for the Window Scaling option in RFC 1323, TCP Extensions for High Performance . A larger window size is recommended to improve TCP performance in network paths with large bandwidth-delay product characteristics that are called Long Fat Networks (LFNs). The 300-101 dumps TCP Window Scaling enhancement provides that support. The window scaling extension in Cisco IOS software expands the definition of the TCP window to 32 bits and then uses a scale factor to carry this 32-bit value in the 16-bit window field of the TCP header. The window size can increase to a scale factor of 14. Typical applications use a scale factor of 3 when deployed in LFNs.
The TCP Window Scaling feature complies with RFC 1323. The larger scalable window size will allow TCP to perform better over LFNs. Use the ip tcp window size command in global configuration mode to configure the TCP window size. In order for this to work, the remote host must also support this feature and its window size must be increased.

You can prepare for the Cisco 300-101 dumps exam with our test products including 300-101 PDF dumps questions, and test preparation software. You can prepare for the Implementing Cisco IP Routing (ROUTE v2.0) exam through practice kits without facing https://www.pass4itsure.com/300-101.html dumps problem.

Read More Youtube:https://youtu.be/Kzd25sHJz1A